hidden hit counter

Preparing New Wood For Staining

Preparing New Wood For Staining

To remove those last bits of finish, palm sand with medium sandpaper (150 grit) until you see the bare wood. Then switch to fine sandpaper (200+ grit) until the entire piece is uniform. Wipe down the whole surface with a tack cloth to remove any dust from sanding.
New wood requires minimal preparation, while old or damaged wood will require additional steps to ensure the best results when staining. This guide will walk .
Do NOT start sanding with very fine sandpaper on unfinished wood. Prepare the surface by using medium paper first, and then proceed to finer grades. On most raw woods, start sanding in the direction of the grain using a #120-150 grit paper before staining and work up to #220 grit paper.
Apply the product with a pump sprayer, then wait 15 minutes. Scrub the wet surface with a stiff bristle brush, then rinse the wood surface thoroughly. Once the surface has completely dried, you're ready to coat with a BEHR stain or finish product.
Where to Work; Top 5 Tips; Choosing a Repair Product; Sanding Tips; Use a Pre-Stain Wood Conditioner; Where to Use a Sanding Sealer; Wood Preparation .
Review the basics of effective wood preparation, finishing & care.. A high-quality brush carries more stain or finish; Your work will be neater, with fewer runs .

More from my site

Leave a Comment